Quality Time and Time Again
RTD Technologies works with a wide variety of companies to make sure that their needs are met. We take orders, but we also love figuring out special cases. RTD has worked with a few companies to help solve problems that no other company could figure out. From small companies to large ones and from small parts to big, RTD can help find the solution or part to any situation. Here are a few of the companies we have helped over the years.
FREUDENBURG
The Challenge
On an injection molded part, a critical area was developing excess flash. Upon a closer look, the issue was inherent to the design of the part & couldn’t be remedied by altering the mold or part.
The Solution
RTD was tasked with designing & building a machine that would be placed on the production floor. The machine would need to remove flash from 4 holes in 15 seconds or less, without leaving residue and with the ability to run 3 shifts a day for approximately 3 years.
The Result
The machine has been running for more than 1 year with only minor maintenance issues. Approximately 150k pcs to date.
The Rubber Group
The Challenge
To produce a Stainless-Steel insert for a rubber seal. A High Volume, low cost part with tight tolerance.
The Solution
Develop the process as to run 2-part sizes lights-out.
The Result
To date we have run more than 150k pcs.
ATCO LANAIR
The Challenge
To Reverse Engineer & Produce a Titanium Bracket at a Competitive enough price to allow for resale.
The Solution
After months of process development, the customer was almost close to abandoning the project. We would not give up & ultimately RTD was successful.
The Result
Over more than 5 years, the customer was able to sell more than 3000 units.
